Here is how I 3d printed the frogs soap dish holder
I researched how to 3d print a soap dish holder for a day. Then I downloaded the file and printed it.
It is gorgeous and the bar soap fits well in it. I made it for my hubby and he loves it.
Check on the Thingiverse link below for the recommended filament.
There are a variety of different colors of filaments which you can use to print this object.
The sky is the limit when it comes to different colors of filaments.
I described it further below…
How to 3D print a soap dish?
I used HATCHBOX 3D Printer Filament, 1 kg Spool, 1.75 mm, Black to print the three wise frogs.
I used EcoTough PLA 2.0 – 1.75mm – 1 Kg red filament to print the dish/base.
These are the steps below which I took to print it:
I downloaded the file from the Thingiverse site.
- I used the Cura software to slice the file and then exported it to the SD card. After that I checked to see whether everything was good on my ender 3 pro 3d printer.
- I placed the filament on the spool holder and then the levelled the bed.
- Inserted the SD card into the printer. Turned the printer on and did auto home on it.
- Checked to see whether the printer’s bed level was accurate by, printing the chep bed file.
- Once it was ready to print, I printed the file from TIF.
- Kept an eye throughout on the printer while it was being printed.
- I let the printer cool down before I took the print off.
- Auto homed the printer and then turned the power button off.
- Took the SD card out of the printer.
